Adjusting The Rockshox Coil Spring With An External Preload Adjuster - Shimano EDISON COMP I-12 Original Operating Instructions

6.5.11.2 Adjusting the RockShox coil spring with an external preload adjuster

Only applies to pedelecs with this equipment
1 Turn the preload adjustment ring anti-
clockwise until it locks into position
anticlockwise.
 The lowest, i.e. softest spring preload is set.
1
Figure 100: Screwing (1) and unscrewing (2) the preload
adjustment ring.
2 Put on normal cycling clothing. Ask someone
to hold the bicycle.
3 Stand on the pedals. Allow the damper to
deflect three times. Sit or stand on the bicycle
in a normal riding position.
4 Ask your helper to push the O-ring downwards
until it reaches the top of the dust wiper seal.
Figure 101: Moving the O-ring on the suspension fork
5 Get off the pedelec without allowing it to
deflect.
MY22H03 - 22_1.0_01.10.2021
6 Note distance between dust wiper and the O-
2
Figure 102: Sag (1)
Table 40: Recommended sag
Figure 103: Mandatory sag range (green) and prohibited
sag range (red)
7 If the desired sag is not achieved, the preload
8 The coil spring must be replaced if the desired
ring. This distance is the sag.
1
Setting
Prohibited
High sensitivity
Low sensitivity
Prohibited
adjustment ring must be unscrewed bit by bit.
sag cannot be achieved by twisting the preload
adjustment ring. Contact your specialist dealer.
Operation
Sag
>30%
20–30%
10–20%
<10
97