Connect External Devices; Connect Via Bluetooth® Le; Connect Via Ant; Using E-Tube Project - Shimano EDISON COMP I-12 Original Operating Instructions

6.7

Connect external devices

Notice
 Do not establish connection to external
devices if the battery is charging.
6.7.1 Connect via Bluetooth® LE

The external device supports Bluetooth® LE
connections.
1 Switch the external device to connection mode.
Follow the operating instructions for the
external device when doing so.
 Drive system will start within 30 seconds of the
external device being placed in pairing mode,
or
 Press any button within 30 seconds of the
external device being placed in pairing mode.
2 Establish connection
 The connection is established.
6.7.2

Connect via ANT


The external device supports ANT connections.
1 Switch the external device to connection mode.
Follow the operating instructions for the
external device when doing so.
2 Switch on the drive system.
3 Establish connection.
 The connection is established.
MY22H03 - 22_1.0_01.10.2021
6.8

Using E-TUBE PROJECT

E-TUBE PROJECT is required to change drive
system settings and update firmware.
The functions that can be configured differ
depending on the pedelec. You will find details in
the E-TUBE PROJECT operating instructions.
• Functions allocated to each operating switch can
be changed.
• The pedelec's settings can also be configured
using E-TUBE PROJECT.
• Settings for ride comfort can be saved and
registered in E-TUBE PROJECT; see "Dynamic
change to ride characteristics [Sup. adjust.]" in
the E-TUBE PROJECT operating instructions.
You will find information on installing E-TUBE
PROJECT on the support website.
 Download E-TUBE PROJECT onto the
connected external device from the SHIMANO
support website:
https://e-tubeproject.shimano.com.
Operation
122