Eightpins Ngs2 Seat Post - Shimano EDISON COMP I-12 Original Operating Instructions

8.5.8.4 eightpins NGS2 seat post

Only applies to pedelecs with this equipment
Removing the seat post
1 Use a 2.5 mm hex key to turn the height
adjustment 45° anti-clockwise and move to the
"Open position".
Figure 177: Moving height adjustment to the "Open
position"
2 Activate operating lever. Pull seat post
upwards at the same time and remove
completely.
Figure 178: Pulling the seat post out
3 Activate operating lever. Hold Bowden cable
fastener and pull or tilt forwards. Remove outer
sleeve from the seat post remote control.
Figure 179: Removing the cartridge
4 Use a 5 mm to undo Postpin axle and pull out.
Figure 180: Undoing the Postpin axle
MY22H03 - 22_1.0_01.10.2021
5 Pull cartridge from the piston rod while pushing
the outer sleeve into the frame at the same
time to help.
Figure 181: Pulling the cartridge out
6 Hold the cartridge with one hand at the height
of the mechanism and pull the Bowden cable
straight down with the other.
7 Hold the white actuating slide in the locking
mechanism with your thumb.
8 Carefully push the Bowden cable upwards with
the other hand and detach it.
Figure 182: Detaching the Bowden cable
Notice
 Never pull Bowden cable forwards at an angle.
Figure 183: Bowden cable position
Maintenance
190