Adjustment; Adjusting The Cassette Joint - Shimano NEXUS SG-C7002-5 Dealer's Manual

Adjustment

Adjusting the cassette joint

Adjustment
Adjusting the cassette joint
1. Operate the shift lever and set to the specified gear position.
SG-S7001 (internal 11-speed): 11-speed to 6-speed
SG-S7001 (internal 8-speed): 8-speed to 4-speed
SG-C6001 / SG-C6011 (internal 8-speed): 1-speed to 4-speed
SG-C7000 / SG-C7002 (internal 5-speed): 5-speed to 3-speed
2. Turn the cable adjustment barrel and align the setting lines.
Check that the yellow setting lines on the cassette joint bracket and pulley are aligned with each other. The
yellow setting lines on the cassette joint are located in two places.
When the bicycle is upright
Pulley
Bracket
Should be aligned
If the area of the pulley and bracket marked by the setting line overlap by two thirds or less, the
gears may not be properly engaged during pedaling, resulting in abnormal noise or free spinning
of the pedals.
3. Operate the shift lever and recheck that the yellow setting lines are aligned.
Operate the shift lever again from step
When the bicycle is upside
down
Pulley
Bracket
Should be aligned
1 to check.
35