Using The Riding Light; Using The Push Assist System; Select Walk Level Of Assistance; Switching On The Push Assist - Shimano EDISON COMP I-12 Original Operating Instructions

MTB control panel
1
2
Figure 146: MTB control panel
1 Switch Y
2 Switch X
Control panel on the left side of the
handlebars
Switch Function
W HE N R ID IN G
X Increase level of assistance
Y Reduce level of assistance
A Switch journey data displayed
W HE N A DJ U ST IN G
X Move cursor or change the settings
Y Move cursor or change the settings
A Change display or confirm setting change
If there is no switch A on the control panel, the
button on the on-board computer will assume
these functions.

6.21.0.1 Using the riding light


The drive system must be switched on.
 Press the light button.
 The light is switched on. The riding light symbol
is shown on the display screen.
 Press the light button.
 The light is switched off.
MY22H03 - 22_1.0_01.10.2021

6.21.1 Using the push assist system

CAUTION
!
Injury caused by pedals
The pedals turn when using the push assist due
to the system design.
 You must steer the bicycle securely with both
hands when using push assist.
 Allow for enough freedom of movement for the
pedals.
The push assist helps the rider to push the
bicycle. The speed can be a maximum of 6 km/h
in this case. The tractive power of the push assist
and its speed can be influenced by the selection
of gear. We recommend using first gear for cycling
uphill to protect the drive.

6.21.1.1 Select WALK level of assistance

 Press switch Y (left) about 2 seconds.
 The level of assistance W AL K is displayed.
 If a warning is sounded during switchover, it is
impossible to switch to the WALK level of
assistance. This may be due to the current
speed not being 0 km/h, pressure being
applied to the pedals or similar.
 Release switch Y (left).

6.21.1.2 Switching on the push assist

 Press switch Y (left) to switch on push assist.

6.21.1.3 Switching off the push assist

 Release switch Y (left) to switch off push
assist.

6.21.1.4 Exit WALK level of assistance

 Push switch X (left) to change from the WALK
level of assistance to the level of assistance
last used.
 If switch Y (left) is not pushed for longer than
one minute, the level of assistance is reset to the
level of assistance used previously.
Operation
132