Miscellaneous - Shimano EDISON COMP I-12 Original Operating Instructions

9.5

Miscellaneous

Symptom
Two beeps will sound if a
switch is pressed but the
switch cannot be operated.
Three beeps are sounded.
In the case of an electronic
gear shift, pedal assistance
becomes weaker when the
gear is changed.
A noise can be heard after
switching.
It is normal to hear a noise
coming from the rear wheel
when cycling as normal.
When the bicycle stops,
gear transmission will not
switch to the position pre-
configured in the functional
feature.
Table 71:Error solution for battery
MY22H03 - 22_1.0_01.10.2021
Cause
Pressed switch mode has been
deactivated.
A fault or warning has occurred.
This is because the computer sets the
pedal assistance to the optimum level.
The gear shift setting may not have been
made properly.
You may have applied too much pressure
on the pedals.
Troubleshooting, fault clearance and repair
Remedy
This is not a malfunction.
 This occurs when a warning or an error is shown on the
display screen. Follow the instructions for the code in
Section 6.2 System Messages.
This is not a malfunction.
 Contact your specialist dealer.
 Contact your specialist dealer.
 It is easier to change gears if you press onto the pedals
gently.
206