Lighting; On-Board Computer Error - Shimano EDISON COMP I-12 Original Operating Instructions

Symptom
The battery cannot be
inserted.
Fluid is leaking from the
battery.
There is an unusual smell.
Fumes are emitted from the
battery.
Table 68:Error solution for battery
9.4

Lighting

Symptom
The front light or rear light
does not go on, even when
the switch is pressed.
Table 69:Error solution for battery
9.4.1

On-board computer error

Symptom
No data is shown on the
monitor when the On-Off
button (battery) is pressed.
The gear level is not shown
on the display screen.
The settings menu cannot be
opened while you are riding.
Table 70:Display error solution
MY22H03 - 22_1.0_01.10.2021
Cause
Cause
The basic settings in the electric drive
system have probably been configured
incorrectly.
The light is defective.
Cause
The battery charge level may be
insufficient.
Is the power switched on?
Is the battery charged?
Is the connector fitted to the power cable
correctly?
A component may be connected which
the system is unable to recognise.
The gear level is only shown if the
electronic gear shift is used.
The product is designed in such a way
that the settings menu cannot be opened
if the system detects that someone is
riding the pedelec. This is not a
malfunction.
Troubleshooting, fault clearance and repair
Remedy
 Contact your specialist dealer.
 Observe all the warnings in Section 2 Safety.
1 Remove the battery from the pedelec immediately.
2 Contact the fire service.
3 Observe all the warnings in Section 2 Safety.
1 Remove the battery from the pedelec immediately.
2 Contact the fire service.
3 Observe all the warnings in Section 2 Safety.
Remedy
 Remove pedelec from service immediately.
 Contact your specialist dealer.
Remedy
 Charge the battery.
 Press the On-Off button (battery) to switch the power
on.
 If the battery is fitted to the pedelec and is being charged,
it cannot be switched on. Interrupt charging process.
1 Check that the power cable connector has not been
disconnected.
2 Contact your specialist dealer if this is not the case.
 Contact your specialist dealer.
1 Check that the power cable connector has not been
disconnected.
2 Contact your specialist dealer if this is not the case.
1 Stop the pedelec.
2 Change settings when stationary only.
205