By.schulz Suspension Seat Post; Suntour Suspension Seat Post - Shimano EDISON COMP I-12 Original Operating Instructions

8.5.8.2 by.schulz suspension seat post

Only applies to pedelecs with this equipment
1 Remove seat post from the frame.
2 Remove safety and protective cover.
3 Clean seat post on the inside and outside.
4 Examine seat post rack for scratches, cracks
and breaks.
 Replaced damaged seat post as specified in
the parts list.
 If the paint protection film is missing or has
worn away, affix a new paint protection film.
5 Lubricate screws in the parallel suspension.
6 Reinsert seat post as per height specifications
in the pedelec pass. Check screws for correct
tightening torques.
Tightening torque G1

M8 seat clamping screw
M5 fixing grub screws
Tightening torque G2

M6 seat clamping screw
M5 fixing grub screws
7 Put on safety and protective cover.
MY22H03 - 22_1.0_01.10.2021

8.5.8.3 Suntour suspension seat post

Only applies to pedelecs with this equipment
1 Remove seat post from the frame.
2 Remove safety and protective cover.
3 Examine seat post rack for scratches, cracks
and breaks.
 Replaced damaged seat post as specified in
the parts list.
 If the paint protection film is missing or has
worn away, affix a new paint protection film.
4 Undo pre-tensioning adjuster and take out
steel spring.
5 Clean seat post on inside and outside.
6 Grease seat post on inside with SR SUNTOUR
no. 9170-001.
7 Lubricate pressure roller with bike chain oil.
20-24 Nm
3 Nm  Lubricate articulated joints in parallel
suspension with bike chain oil.
12-14 Nm
3 Nm
Figure 176: SR Suntour suspension seat post lubrication
points
8 Reinsert seat post as per height specifications
in the pedelec pass.
9 Check screws for correct tightening torques.
Tightening torque

Seat clamping screw
M5 fixing grub screws
10 Put on safety and protective cover.
Maintenance
1
15-18 Nm
3 Nm
189