Shimano EDISON COMP I-12 Original Operating Instructions page 194

5 Use a 3 mm hex spanner to screw the valve lid
back on and tighten with a maximum of 0.5 Nm.
Figure 196: Fastening the cartridge valve lid
Notice
 The cartridge is not airtight without the valve
lid.
Setting the slipper clutch
1 Use 3 mm hex spanner to unscrew valve cap.
Figure 197: Unscrewing the valve cap
2 Secure the mounting interface against twisting
with a 24 mm open-end spanner.
Figure 198: Securing against twisting
MY22H03 - 22_1.0_01.10.2021
3 Set the torque to 18 Nm with a torque wrench
and a 6 mm hex bit with a shaft length of at
least 25 mm. Rotate clockwise.
.
Figure 199: Setting in a clockwise direction
4 Use a 3 mm hex spanner to screw the valve lid
on and tighten with a maximum of 0.5 Nm.
Figure 200: Fastening the cartridge valve lid
Notice
 The cartridge is not airtight without the valve
lid.
Maintenance
193