6.19.2 Inserting the BT-E8036 battery
1 Place battery into the mount with the contacts
facing the front.
2 Push battery into the frame.
.
1
Figure 140: Inserting the BT-E8036 battery
It will click.
The battery is firmly positioned in the frame.
3 Check battery is firmly in position.
6.19.3 Charging the battery
If an error occurs during the charging process, a
system message is displayed. Remove the
charger and battery from operation immediately
and follow the instructions.
Contact your specialist dealer if you are unable to
recharge the battery or it is damaged.
The battery can remain on the pedelec or can be
removed for charging.
1 Remove the rubber cover from the battery.
2 Connect the mains plug of the charger to a
normal domestic, grounded socket. Connect
the charging cable to the battery's charging
port.
The charging process starts automatically.
The LED light on the charger will light up once
charging starts.
MY22H03 - 22_1.0_01.10.2021
2
1
Figure 141: LED light on the charger (1)
The LED on the charger has three statuses:
Status
Lights up
Flashes
Off
Table 55: SHIMANO battery LED symbols
*1 hour or longer after the charging process is complete
1 hour or longer after an error has occurred
If an error occurs during the charging process,
a system message is displayed. Remove the
charger and battery from operation immedi-
ately and follow the instructions.
Regularly check the current battery level.
Rechargeable battery
BT-E8020
BT-E8036
Table 56: Intended charging time for the EC-E6002
Charging is complete when the LEDs on the
battery level indicator go out.
Operation
Meaning
Charging
Charge error
Battery disconnected*
Charging time
About 7.5 hours
About 10.25 hours
129