Battery Error Message - Shimano EDISON COMP I-12 Original Operating Instructions

6.3.3

Battery error message

The battery indicates errors with different LED
statuses.
Type Status
System error Communication error with
the pedelec system.
Temperature protection If the temperature exceeds
the guaranteed operating
range, the battery will
switch off.
Error during security This is displayed if no
authentication original drive unit is
connected. This is
displayed if one of the
cables is not connected.
Charge error This is displayed if an error
occurs during the charging
process.
Battery malfunction Electrical fault in the
battery.
Table 33: Battery error messages
MY22H03 - 22_1.0_01.10.2021
Symbols:
.
LED on
Lighting pattern Remedy
1 Check that the charging cable is firmly and properly
connected.
2 Contact your specialist dealer if the problem persists.
1 Store battery in a cool place where there is no direct
sunlight until the battery interior temperature has
fallen sufficiently.
2 Contact your specialist dealer if the problem persists.
1 Connect original rechargeable battery and original
drive unit.
2 Check state of cables.
3 Contact your specialist dealer if the problem persists.
1 Remove connector between battery and charger.
2 Press the On-Off button (battery) while the battery is
connected.
3 Contact your specialist dealer if the problem persists.
1 Connect charger to the battery.
2 Remove charger.
3 Press the On-Off button while the battery is
connected.
4 Contact your specialist dealer if the problem persists.
Operation
LED off LED flashing
75