Intended Use; Improper Use; Residual Risk; Machine Modification - Trotec SpeedMarker 700 FL Operating Manual

Safety
3.1.1

Intended use

The SpeedMarker 700 FL is a Class 2 laser marker as per DIN EN 60825-1 "Safety of laser products". It is intended for
integration in systems and lines.
The product is intended exclusively for laser marking using the supplied marking soware.
The following points should also be observed as part of the intended use:
Notice
–
Only mark approved materials using suitable parameters.
– Perform maintenance and service according to the specifications in this operating manual.
– Use a suitable extraction system to remove fumes, dust or other reaction products.
–
The machine may only be operated by suitably trained individuals.
– Observe effective safety regulations and the procedures described in this operating manual.
If the intention is to use the system for other applications, Trotec Laser GmbH should be informed in advance.
3.1.2

Improper use

Use of the machine for any purposes other than those intended or described in the present manual is regarded as
improper and therefore prohibited. Trotec Laser GmbH will not accept any liability for damage caused by improper use.
The operator is solely liable for all damages caused by improper use.
Non-observance of the operation, maintenance and service instructions described within this manual absolves Trotec
from any liability in case of a defect.
3.1.3

Residual risk

Even if all safety regulations are observed, a residual risk remains when operating the machine.
The measures required to reduce all residual risks can be found in the following paragraphs of the chapter "Safety".
3.1.4

Machine modification

It is strictly prohibited to alter, refit or modify the machine in any way without the express consent of the manufacturer.
Likewise, it is strictly prohibited to remove, bridge or bypass any safety devices. Operating conditions and connection
and setup values stated in the data sheet must be complied with at all times.
Operation of the system is permitted only with original parts and accessories by the manufacturer. Use of third-party
parts affects machine safety.
14