Set The Button Operation Mode; Set The Button Interaction State; Set The Button Name; Set The Icon For The Button - Lightware RAP-B511-EU User Manual

   
7. LW3 Programmers' Reference
7.7.3. Set the Button Operation Mode
Command and Response
SET·/MANAGEMENT/UI/BUTTONS/<btn_ID>.Mode=<btn_mode>
ç
pw·/MANAGEMENT/UI/BUTTONS/<btn_ID>.Mode=<btn_mode>
æ
Parameters
Identifier Parameter description
<btn_mode> Shows the button type.
It can be momentary or
toggle or radio.
Example
ç SET /MANAGEMENT/UI/BUTTONS/BUTTON1.Mode=1
æ pw /MANAGEMENT/UI/BUTTONS/BUTTON1.Mode=1
Parameter values
0: Momentary: Simple button function, when the button is pressed,
the action will execute.
When the button is pressed, the <btn_ID>.State-=true
▪
▪ When the button is released, the <btn_ID>.State=false
1: Toggle: This button type toggles between two states
(e.g. control turning on and off the light with one button).
▪ When the button is pressed, the <btn_ID>.State changes.
▪ When the button is released, the <btn_ID>.State does not change.
2-6: Radio: It defines the assigned radio group of the button. One
button can belong to one group at the same time.
When the button is pressed, the <btn_ID>.State changes true and
<btn_ID>.State of the other members in the same group changes
false.
2: Member of group 1;
3: Member of group 2;
4: Member of group 3;
5: Member of group 4;
6: Member of group 5.
Applied firmware package: v1.1.0b3b3 | LDC software: v2.5.1b5
RAP-B511 series – User's Manual
7.7.4. Set the Button Interaction State
This property gives immediate feedback about the button status, which changes depending on the button
mode. When the button function is configured with Lightware Device Controller Software, this parameter is
set as a Condition in the Event Manager.
Command and Response
SET·/MANAGEMENT/UI/BUTTONS/<btn_ID>.State=<btn_state>
ç
pw·/MANAGEMENT/UI/BUTTONS/<btn_ID>.State=<btn_state>
æ
Parameters
Identifier Parameter description
<btn_state> Button state
Example
ç SET /MANAGEMENT/UI/BUTTONS/BUTTON1.State=true
ç pw /MANAGEMENT/UI/BUTTONS/BUTTON1.State=true
7.7.5. Set the Button Name
Command and Response
ç SET·/MANAGEMENT/UI/BUTTONS/<btn_ID>.
æ pw·/MANAGEMENT/UI/BUTTONS/<btn_ID>.
Parameters
Identifier Parameter description
<btn_name> Button name
Example
ç SET /MANAGEMENT/UI/BUTTONS/BUTTON1.Name=Projector on
ç pw /MANAGEMENT/UI/BUTTONS/BUTTON1.Name=Projector on
7.7.6. Set the Icon for the Button
Command and Response
SET·/MANAGEMENT/UI/BUTTONS/<btn_ID>.IconId=<icon_ID>
ç
æ pw·/MANAGEMENT/UI/BUTTONS/<btn_ID>.
Parameters
Identifier Parameter description
<icon_ID> It defines the displayed icon of the button
in the Miniweb or the LDC layout.
Parameter values
true or false: It gives a feedback about the current state
of the button, which changes depending on the
Button Operation Mode.
Name=<btn_name>
Name=<btn_name>
Parameter values
The button name can be 33 character-long,
ASCII characters are allowed. Longer names are not accepted.
IconId=<icon_ID>
Parameter values
i1-i140: Sets the pictogram on the button.
74
Set the