Configuration Cloning (Backup Tab) - Lightware RAP-B511-EU User Manual

   
5. Software Control - Lightware Device Controller
Press the Clear button to remove the control page. In this case, status information becomes available about
the device.

INFO: Status information is always available at http://<device_IP_address>/status.html page.
Miniweb Status Page
Applied firmware package: v1.1.0b3b3 | LDC software: v2.5.1b5
RAP-B511 series – User's Manual
5.9. Configuration Cloning (Backup Tab)
The configuration cloning of Lightware LW3 devices is a simple method that eliminates the need to repeatedly
configure certain devices to have identical (non-factory) settings. If the devices are installed in the same
type of system multiple times then it is enough to set up only one device to fit the user's needs and then copy
those settings to the others, thus saving time and resources.

ATTENTION! Macros cannot be saved into the backup file. If you have macros stored in a Configuration
slot, download it separately and upload it in the target device.
Backup tab in Settings menu
55