Table of Contents
Advertisement
6. LW2 Programmer's Reference
6.3. General LW2 Commands
6.3.1. Querying the Supported Commands
The LW2 commands supported by the device can be queried by this command.
Command and Response
#producttype
{LCMD}
(LCMD# <command>: <description>)CrLf
...
(LCMD END)CrLf
Example
{lcmd}
(LCMD# LCMD: List all commands)
(LCMD# PING: Always response PONG)
(LCMD# CT: Compile time)
...
(LCMD END)
INFO:
The response is longer, not all the lines can be seen in the example.
6.3.2. Querying the Product Type
The device responds its name.
Command and Response
#producttype
{i}
(I:<PRODUCT_TYPE>)CrLf
Example
{i}
(I:RAP-B511-US-W)
6.3.3. Querying the Device Label
The respond shows the device label which is a read-only parameter in LW2, but it can be changed by an LW3
command, see the
Set the Device Label
Command and Response
{LABEL}
(LABEL=<device_label>)CrLf
Example
{label}
(LABEL=RAP-B511_ENG-6517)
section.
Applied firmware package: v1.1.0b3b3 | LDC software: v2.5.1b5
RAP-B511 series – User's Manual
6.3.4. Querying the Control Protocol
The device can be controlled with different control protocols. This command queries the active protocol of
the currently used control interface.
Command and Response
#protocol
{P_?}
(CURRENT·PROTOCOL·=·#<protocol>)CrLf
Example
{p_?}
(CURRENT PROTOCOL = #1)
'#1' means the device communicates with LW2 protocol.
6.3.5. Querying the Current Firmware Package Version
Command and Response
{F}
(FW:<FW_VER>)CrLf
Example
{f}
(FW:1.0.3b2)
<FW_VER>
is the firmware package version.
6.3.6. View Firmware for All Controllers
Shows the firmware versions of all installed controllers.
Command and Response
#firmwareversion
{FC}
(CF·<DESC>)CrLf
(CF·<DESC>)CrLf
...
(CF END)CrLf
Example
{fc}
(CF RAP-B511-US-W v1.0.3b2)
(CF END)
The device has one control panel.
60
Advertisement
Table of Contents
Troubleshooting
