Ethernet - Lightware RAP-B511-EU User Manual

   
5. Software Control - Lightware Device Controller
5.5.3. Ethernet
Ethernet Ports
Two ports are displayed in the Ethernet settings: PoE in Eth and PoE out Eth. You can check the status of the
Ethernet line by each ports: the speed and the duplexity of the connection.
The following settings are available for each ports:
Enable / disable the port,
▪
▪ Reload the factory defaults.
The PoE feature can be enabled/disabled on PoE out Ethernet port.
Ports tab in the Control/Ethernet menu
Applied firmware package: v1.1.0b3b3 | LDC software: v2.5.1b5
RAP-B511 series – User's Manual
HTTP Clients (HTTP Post and Put Message Sending)

ATTENTION! This feature means posting or putting HTTP messages from the Lightware device to another
device. Encrypted transmission (HTTPS) is not supported.
The HTTP Clients tab allows sending HTTP post and put messages to the desired server IP:port no. Control
commands can be set to the target device, but it is not suitable for processing the response (e.g. querying a
parameter/status. #http
The feature is available also by LW3 commands, see the
When you press the enter in the Http header or Http body text box, the \r\n is added automatically.
#new
HTTP Messaging section.
HTTP Clients tab in the Control/Ethernet men
41