Control Menu - Lightware RAP-B511-EU User Manual

   
5. Software Control - Lightware Device Controller
Schema ID
MMX6X2-HT200
Generic LWR-D MMX6X2-HT210
MMX6X2-HT220
MX-FR (IB/OB-A)
Generic LWR-E UMX-OPT-TX150R
UMX-TP-TX100
Generic LWR-F UBEX-PRO20-HDMI-F110, -F120
VINX-120AP-HDMI-ENC
VINX-120AP-HDMI-ENC-DNT
Generic LWR-G
VINX-210AP-HDMI-ENC
VINX-110AP-HDMI-DEC
Device Type
Applied firmware package: v1.1.0b3b3 | LDC software: v2.5.1b5
RAP-B511 series – User's Manual
5.5. Control Menu
5.5.1. RS-232
The following settings and functions are available (both on local and TPS serial ports):
Operation mode: Control, Command Injection, or Disconnected (for more details about serial interface
▪
modes see the Serial Interface
▪ Baud rate: 4800, 7200, 9600, 14400, 19200, 38400, 57600, 115200;
Data bits: 8 or 9;
▪
▪ Parity: None, Odd, or Even;
▪ Stop bits: 1, 1.5, or 2;
Command injection: enable or disable; port number;
▪
Control protocol: LW2 or LW3;
▪
▪ Message sending via serial port;
▪ Reloading factory defaults (see factory default settings in the
RS-232 Tab in Control Menu
section);
#commandinjection
#protocol #rs232 #rs-232 #serial
#message
Factory Default Settings
39
section).