Rotary - Lightware RAP-B511-EU User Manual

   
4. Device Concept
Summary of the button operation modes
PRESS
interaction state true
PRESS
interaction state true
PRESS
1 2
interaction state
true false false
Flowchart of the button configuration process
User interaction Operation mode
Button press
Button release
INFO:
All settings of the button functions are available in the Lightware Device Contoller software (see
the details in Buttons section) or via LW3 protocol commands (for more details see
section).
Momentary Operation Mode
RELEASE PRESS
false true
Toggle Operation Mode
RELEASE PRESS
true false
Radio Group Operation Mode
RELEASE PRESS
3 1 2 3 1 2 3
true false false false true false
Interaction state
Momentary
Changes /
not changes,
Toggle
true / false
Radio Group
Applied firmware package: v1.1.0b3b3 | LDC software: v2.5.1b5
RAP-B511 series – User's Manual
4.2.2. Rotary
The jog dial knob is designed for volume control (in a 16-level scale), but it can be used for other controlling
purposes, too.
RELEASE
Turning left and right the rotary changes the volume value from 0
to 16. The volume values are the conditions, which are assigned
to the control commands (e.g. SET /MEDIA/PORTS/VIDEO/O2/
ANALOGAUDIO.VolumedB=-96\x0d\x0a). When the rotary reaches
the proper position, the action will be executed.
false The control command can be sent over RS-232 or Ethernet (in this
case, the IP address of the target device is needed).
LWR Volume Control Schema supports to load the LW3 command list automatically for controlling the volume
RELEASE
(and the mute/unmute state) of the Lightware devices. Choose the proper schema (see more details about
the compatibility table in
Custom Volume Control Schema makes it possible to configure any command for controlling a third-party device.
Knob press toggles between the muted and the unmuted states. When the Custom schema is loaded, press
and release event can be configure for any purpose.
false Flowchart of the rotary configuration process
RELEASE
User interaction
1 2 3
false true false

INFO:
can be found in
see
Action
Executed
Not extecuted
Button Configuration
Configurations of the Rotary section) and fill the audio port number.
Input:
Output:
Interface
Rotary turn Ethernet
Rotary press RS-232
Customizing the rotary functions is possible with Lightware Device Contoller software (the details
Configurations of the Rotary section) or with LW3 protocol commands (for more details
Volume Control Configuration section).
24
Volume control
Action
schema
Mute /unmute,
LWR
volume up /
volume down
Any action
Custom