Table of Contents
Advertisement
5. Software Control - Lightware Device Controller
5.6.2. The Event Editor
Press the Edit button in the desired Event line to open the Event editor window.
1
2
3
4
1
Event header
The name of the Event is displayed. Type the desired name and press the Set
name button. The Event can be cleared by the Clear button. Use the tick mark
to enable/disable the Event.
Condition header
If the condition is set, the description (white colored text) and the exact LW3
2
protocol expression (yellow colored text) can be seen. If the advanced mode
was used the description is Custom condition.
3
Condition panel
The Wizard, the Advanced or the Link tool is available to set the condition.
The parameters and settings are displayed below the buttons.
Condition test
The set condition can be tested to see the working method in the practice.
4
Delay settings
The action can be scheduled to follow the condition after the set time value.
5
Action header
If the action is set, the description (white colored text) and the exact LW3
6
protocol expression (yellow colored text) can be seen. If the advanced mode
was used the description is Custom action.
7
Action panel
The Wizard, the Advanced or the Link tool is available to set the action. The
parameters and settings are displayed below the buttons.
Action test
The set action can be tested to see the working method in the practice.
8
5
Applied firmware package: v1.1.0b3b3 | LDC software: v2.5.1b5
RAP-B511 series – User's Manual
5.6.3. Create or Modify an Event
Wizard Mode
The wizard mode lists the most common
conditions and actions, so the user does not
have to look for LW3 nodes and properties.
6
Step 1. Click on the Edit button of the desired
Event; the Event editor is displayed.
Step 2. The wizard mode is displayed as
default. Select the desired Category first
(e.g. Audio or Video).
Step 3. Select the desired Expression from
7
the drop-down menu. If any other
parameter is necessary to set, it is
going to be displayed.
Step 4. Press the Apply button to store the
settings of the Condition.
INFO:
This mode is also available for setting
the Action.
8
Advanced Mode
The goal of this mode is the same as of the wizard: set the properties and methods for conditions and
actions. The difference is the number of the available and usable properties and methods of the LW3
protocol. Advanced mode allows almost all of it.
Step 1. Click on the Edit button of the
desired Event; the Event editor is
displayed.
Step 2. The wizard mode is the default,
press the Advanced button. The LW3
protocol tree is displayed showing
the list of the properties in the drop-
down menu. Navigate to the desired
node.
Step 3. Select the desired Property from the
menu. The manual of the property
is displayed below to help to select
the necessary property and to set
the value.
Step 4. Set the desired value and operator,
then press the Apply button to store
settings.
INFO:
This mode is also available for
setting the Action.
48
Advertisement
Table of Contents
Troubleshooting
