Advanced View Window - Lightware RAP-B511-EU User Manual

   
5. Software Control - Lightware Device Controller
5.10. Advanced View Window
1
4
5
2 3
Applied firmware package: v1.1.0b3b3 | LDC software: v2.5.1b5
RAP-B511 series – User's Manual
LW3 protocol Pushing the button results a help window opening which describes the most important
1
help information about LW3 protocol commands in HTML format.
Edit mode The default appearance is the read-only mode. If you want to modify the values or parameters,
2
tick the option. You will be prompted to confirm your selection.
3 Warning mode If this is checked, a warning window pops up when you enable Edit mode.
4 Terminal Commands and responses with time and date are listed in this window. Sent command starts
window with '>' character, received response starts with '<' character. The color of each item depends on
the type of the command and response. The content of the window can be emptied by the Clear
button. If the Autoscroll option is ticked, the list is scrolled automatically when a new line is added.
7
5 Command line Type the desired command and execute it by the Send button. Clear all current commands and
responses in the Terminal window by the Clear button. The commands typed in this line are not
escaped automatically. See more information in the
6 Protocol tree LW3 protocol tree; select an item to see its content.
6
7 Node list Correspondent parameters and nodes are shown which are connected to the selected item in
the protocol tree. The commands typed in these fields are escaped automatically.
Manual button:
Set button:
Call button:
Escaping section.
Manual (short description) of the node can be called and displayed in the
terminal window.
Saves the value/parameter typed in the textbox.
Calls the method, e.g. reloads factory default settings.
57