Front View; Rear View - Lightware RAP-B511-EU User Manual

   
2. Product Overview
2.1. Front View
INFO:
All the models have the same look and controls on the front panel, the only difference is the size
and the color of the enclosure.
1

INFO: The labels of the buttons are just for illustration since the button caps are empty by default. The
user can insert the desired label from the attached sheet.
1
Buttons 11 configurable buttons with short and long press detection.
Each button has a programmable background light. They can be configured for
immediate feedback of pushing the buttons or can be set to five different modes:
off / low bright / high bright / slow blink / sine pulse. Blinking of the button and
rotary LEDs three times means, that the front panel functionality is locked. Unlocking
is possible with
commands (for more details see
2 Rotary Eight green-colored LEDs for giving feedback about the current position of the jog dial knob.
LEDs
full bright
half bright
off
3 Rotary Jog dial for volume control on a 16-level scale or it can be programmed for other
knob controlling purposes by turning and clicking the knob.
4 Mute LED It gives feedback about the mute status of the volume. It can be toggled on and off by
pushing the rotary knob.
on
off
blinking
5 IR detector
Built-in IR eye to receive infra signal.
2 3 4
Software Control - Lightware Device Controller
LW3 Programmers' Reference section).
As the jog dial is rotated right (and the volume increases), the LEDs
turn on one-by-one. One level means half brightness. The picture on
the left shows that the volume is set 11.
The volume is muted.
The volume is unmuted.
The device is in bootload mode. Press the rotary knob for 5 sec for
changing to the normal operation mode.
Applied firmware package: v1.1.0b3b3 | LDC software: v2.5.1b5
RAP-B511 series – User's Manual
2.2. Rear View
5
1
2
3
4
or via LW3 protocol
1
2
3
GPIO 4-pole Phoenix connector for configurable general purpose.
®
RS-232 port 3-pole Phoenix connector for bi-directional serial communication.
®
DC Input The device can be powered by a local adaptor. Connect the output to the 2-pole
Phoenix connector. For more information about the powering, see
®
section.
Ethernet Two RJ45 connectors for Ethernet communication. Both of them are PoE-compatible,
ports one is a PoE receiver, the other can send PoE (PoE sending is available when the device
is locally powered).
13
4
Powering Options