Special Functions; Behind The Front Panel; Restarting The Device; Entering Bootload Mode - Lightware RAP-B511-EU User Manual

   
2. Product Overview
2.3. Special Functions
2.3.1. Behind the Front Panel
After removing the front plate (no special tool needed, just pull apart by hand),
a USB connector, a reset button, and a live led can be seen.
1
1 USB mini-B connector can be used for LDC access or firmware upgrade.
USB Port
2 Hidden button to restart the device.
Reset Button
3 Factory defeault Hidden button to reload the
4 Live LED
blinking The unit is powered and ready to use.
on
off
DIFFERENCE:
The hidden button for reloading the factory default settings is available from HW v1.1.
2.3.2. Restarting the Device
Step 1. Keep the 5th and the 9th button pressed for 10 seconds.
Step 2. Release the buttons. The mute LED lights up when the device
restarts.
2
3
4
Factory Default Settings. #new
The device is powered, but the CPU is not running.
The unit is NOT powered or out of operation.
Applied firmware package: v1.1.0b3b3 | LDC software: v2.5.1b5
RAP-B511 series – User's Manual
2.3.3. Entering Bootload Mode
It may happen that the firmware upgrade process is unsuccessful
and the device cannot be switched to bootload mode automatically.
In this case, the device can be forced into bootload mode as follows:
Step 1. Make sure the device is powered off.
Step 2. Press and keep pressed the Rotary knob.
Step 3. Power on the RAP-B511 while the Rotary knob is being
pressed. If the device is switched to bootload mode the Mute
LED is blinking quickly. Release the knob.
The other LEDs are off. The procedure of firmware upgrade can be found in the

INFO: Press the rotary for 5 sec to switch the normal operation mode.
14
Firmware Upgrade chapter.