Terminals - Mitsubishi Electric EZMOTION MR-E Super MR-E-10A-QW003 Instruction Manual

3. SIGNALS AND WIRING
(2) For 1-phase 230VAC power supply
1-phase 230VAC
www.DataSheet4U.com
Note. To use the built-in regenerative resistor, be sure to connect across P and D of the power supply connector (CNP1).

3.7.2 Terminals

Refer to section 11.1 (4) for the signal arrangement.
Connected terminal
(Application)
Power supply
Servo motor
Regenerative option
Protective earth (PE)
Emergency
OFF
stop
NFB MC
(Note)
Emergency stop
Servo-on
Symbol
Supply L , L and L with the following power.
1 2 3
For 1-phase 230VAC, connect the power supply to L
L
1
Servo amplifier
Power supply
L
3-phase 200 to 230VAC,
2
50/60Hz
1-phase 230VAC,
50/60Hz
L
3
U Connect to the servo motor power terminals (U, V, W). During power-on, do not open
or close the motor power line. Otherwise, a malfunction or faulty may occur.
V
W
To use the built-in regenerative resistor of the servo amplifier, connect the wiring across
P
P-D of the power supply connector (CNP1).
C When using the regenerative option, always remove the wiring from across P-D and
connect the regenerative option across P-C.
D
Refer to section 13.1.1 for details.
Connect this terminal to the protective earth (PE) terminals of the servo motor and
control box for grounding.
ON
MC
RA MC
SK
CNP1
Servo amplifier
L
1
L
2
L
3
P
D
C
EMG
SON
VIN
VIN
ALM
SG
Description
, L and L
1 2
MR-E-10A-QW003 to
MR-E-70A-QW003
L
1
L L
1 2
3 - 35
External
power
Trouble
supply
RA
24VDC
open.
3
MR-E-100A-QW003/
MR-E-200A-QW003
L L
2 3