Mitsubishi Electric EZMOTION MR-E Super MR-E-10A-QW003 Instruction Manual page 191

13. OPTIONS AND AUXILIARY EQUIPMENT
3) When fabricating the encoder cable
When fabricating the cable, prepare the following parts and tool, and fabricate it according to the
wiring diagram in 2). Refer to section 13.2.1 for the specifications of the used cable.
www.DataSheet4U.com
(c) MR-J3JCBL03M-A1-L MR-J3JCBL03M-A2-L
The servo amplifier and servo motor cannot be connected with these cables only. The servo motor side
encoder cable (MR-EKCBL M-L/H) is required.
Parts/tool
Connector set MR-ECNM
Servo amplifier side connector
Receptacle: 36210-0100PL
Shell kit: 536310-3200-008
(3M)
Or
Connector set: 54599-1019
(Molex)
Cable model Cable length
MR-J3JCBL03M-A1-L
0.3m
MR-J3JCBL03M-A2-L
Description
Encoder side connector
Housing: 1-172161-9
Connector pin: 170359-1
(Tyco Electronics or equivalent)
Cable clamp: MTI-0002
(Toa Electric Industries)
Protective
Flex life
structure
IP20 Standard
13 - 16
Application
For HF-KE W1-S100 servo motor
Load side lead
Use in combination with MR-EKCBL
M-L/H.
For HF-KE W1-S100 servo motor
Opposite-to-load side lead
Use in combination with MR-EKCBL
M-L/H.