Cable - Mitsubishi Electric EZMOTION MR-E Super MR-E-10A-QW003 Instruction Manual

14. SERVO MOTOR
(1) Do not use the servo motor with its cable soaked in oil or water. (Figure on the right)
www.DataSheet4U.com
(2) When the servo motor is to be installed with the shaft end at top, provide measures so that it is not exposed
to oil and water entering from the machine side, gear box, etc.
(3) If the servo motor is exposed to oil such as coolant, the sealant, packing, cable and others may be affected
depending on the oil type.
(4) In the environment where the servo motor is exposed to oil mist, oil, water, grease and/or like, the servo
motor of the standard specifications may not be usable. Contact us.

14.3.5 Cable

The power supply cable, brake cable and encoder cables connected to the servo motor should be fixed to the
servo motor to keep them from moving. Otherwise, cable breaks may occur. In addition, do not modify the
connectors, terminals and others at the ends of the cables.
Cover
Servo
motor
Oil/water pool
<Incorrect> Capillary phenomenon
Gear
Lubricating oil
Servo motor
14 - 9