Installation; Environmental Conditions - Mitsubishi Electric EZMOTION MR-E Super MR-E-10A-QW003 Instruction Manual

2. INSTALLATION

2. INSTALLATION
www.DataSheet4U.com
CAUTION

2.1 Environmental conditions

Environment
Ambient
temperature
Ambient
humidity
Ambience
Altitude
Vibration
Stacking in excess of the limited number of products is not allowed.
Install the equipment to incombustibles. Installing them directly or close to
combustibles will led to a fire.
Install the equipment on incombustible material. Installing them directly or close to
combustibles will lead to a fire.
Do not get on or put heavy load on the equipment to prevent injury.
Use the equipment within the specified environmental condition range. (For details
of the environmental condition, refer to section 2.1.)
Provide an adequate protection to prevent screws, metallic detritus and other
conductive matter or oil and other combustible matter from entering the servo
amplifier.
Do not block the intake/exhaust ports of the servo amplifier. Otherwise, a fault may
occur.
Do not subject the servo amplifier to drop impact or shock loads as they are
precision equipment.
Do not install or operate a faulty servo amplifier.
When the product has been stored for an extended period of time, consult
Mitsubishi.
When treating the servo amplifier, be careful about the edged parts such as the
corners of the servo amplifier.
[ ] 0 to 55 (non-freezing)
In operation
[ ] 32 to 131 (non-freezing)
[ ] 20 to
In storage
[ ] 4 to 149 (non-freezing)
In operation
90 RH or less (non-condensing)
In storage
Indoors (no direct sunlight)
Free from corrosive gas, flammable gas, oil mist, dust and dirt
Max. 1000m above sea level
2 2
[m/s ] 5.9 [m/s ] or less
Conditions
65 (non-freezing)
2 - 1