D-Link DES-3250TG Reference Manual page 50

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
config ports
Syntax config ports [<portlist/all>] {speed
[auto/10_half/10_full/100_half/100_full/
1000_half/1000_full]
learning [enabled/disabled]
state [enabled/disabled]}
Description This command allows for the configuration of
the switch's Ethernet ports. Only the ports
listed in the <portlist> will be affected.
Parameters all − Displays all ports on the switch to be
configured.
portlist − Specifies a range of ports to be
configured. The port list is specified by listing
the beginning port number and the highest port
number of the range. The beginning and end of
the port list range are separated by a dash. For
example, 3 would specify port 3. 4 specifies port
4. 3-4 specifies all of the ports between port 3
and port 4 − in numerical order.
auto − Enables auto-negotiation for the specified
range of ports.
[10/100/1000] − Configures the speed in Mbps
for the specified range of ports.
[half/full] − Configures the specified range of
ports as either full- or half-duplex.
learning
disables the MAC address learning on the
−
[enabled/disabled]
50
Enables or