D-Link DES-3250TG Reference Manual page 158

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
config link_aggregation
Purpose Used to configure a previously created link
aggregation group.
Syntax config link_aggregation group_id <value>
{master_port <port>/ports <portlist>/
state [enabled/disabled]
Description This command allows you to configure a
link aggregation group that was created
with the create link_aggregation command
above.
<value> − Specifies the group id. The
Parameters
switch allows up to 6 link aggregation
groups to be configured. The group number
identifies each of the groups.
<port> − Master port ID. Specifies which
port
aggregation group will be the master port.
All of the ports in a link aggregation group
will share the port configuration with the
master port.
<portlist> − Specifies a range of ports that
will belong to the link aggregation group.
The port list is specified by listing the
beginning port number and the highest
port number of the range. The beginning
and end of the port list range are separated
by a dash. For example, 3 would specify
port 3. 4 specifies port 4. 3-4 specifies all
of the ports between port 3 and port 4 − in
(by port number) of
158
the link