D-Link DES-3250TG Reference Manual page 124

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
config 802.1p default_priority
settings on the switch. If an untagged
packet is received by the switch, the priority
configured with this command will be
written to the packet's priority field.
Syntax config 802.1p default_priority
[<portlist>/all] <priority 0-7>
Description This command allows you to specify default
priority
received by the switch. The priority value
entered with this command will be used to
determine which of the four hardware
priority queues the packet is forwarded to.
Parameters <portlist> − Specifies a range of ports to be
configured. The port list is specified by
listing the beginning port number and the
highest port number of the range. The
beginning and end of the port list range are
separated by a dash. For example, 3 would
specify port 3. 4 specifies port 4. 3-4
specifies all of the ports between port 3 and
port 4 − in numerical order.
all − Specifies that the command applies to
all ports on the switch (or in the switch
stack).
<priority 0-7> − The priority value you want
to assign to untagged packets received by
the switch or a range of ports on the switch.
Restrictions Only administrator-level users can issue
this command.
handling of untagged
124
packets