D-Link DES-3250TG Reference Manual page 164

DES-3250TG Layer 2 Fast Ethernet Switch User's Guide
config ipif System
[enabled/disabled]/bootp/dhcp}]
Description This command is used to configure the
System IP interface on the switch.
<vlan_name 32> − The name of the VLAN
Parameters
corresponding to the System IP interface.
<network_address>
netmask of the IP interface to be created.
You can specify the address and mask
information using the traditional format
(for example, 10.1.2.3/255.0.0.0 or in
CIDR format, 10.1.2.3/16).
state [enabled/disabled] − Allows you to
enable or disable the IP interface.
bootp − Allows the selection of the BOOTP
protocol for the assignment of an IP
address to the switch's System IP interface.
dhcp − Allows the selection of the DHCP
protocol for the assignment of an IP
address to the switch's System IP interface.
Restrictions Only administrator-level users can issue
this command.
Example Usage:
To configure the IP interface System:
local>config ipif System ipaddress 10.48.74.122/8
Command: config ipif System ipaddress 10.48.74.122/8
−
IP address
164
and