Default Dial-In Setup - D-Link DI-106 Series User Manual

workstations on a remote network. For the router to be set up as
a dial-in server, you need to configure the Default Dial-In Setup
to set the operational parameters for incoming call. Additionally,
you will have to create a Remote Node for the router on the
remote network (see the Remote Node Configuration chapter
starting on page 57). An example of a DI-106 or DI-106M being
used as a dial-in server is shown below:

Default Dial-In Setup

This section covers the default dial-in parameters. The
parameters in menu 13 affect incoming calls from all Remote
Dial-in Users and Remote Nodes before authentication is
completed. Once authentication is completed, and if it matches a
Remote Node, the router will use parameters from that
particular Remote Node.
70 Dial-In Configuration