How To Install The Product; How To Install The Product Using The Mounting Bracket - Eurotech ReliaGATE 10-12-6 Series User Manual

ReliaGATE 10-12 User manual Rev. 2-1
16 H
OW TO INSTALL THE PRODUCT
The product is intended for professional use and must be installed by qualified personnel only.
The product must be installed in a secured location, accessible to authorized personnel only (for
example in a cabinet / technical compartment).
By default, the ReliaGATE 10-12 comes with a Mounting Bracket fastened on the bottom side. You can
use this Mounting Bracket to install the ReliaGATE 10-12.
Optionally, you can replace the Mounting Bracket with the DIN Rail Mounting Clip (optionally available).
You can then use this DIN Rail Mounting Clip to install the ReliaGATE 10-12.
See also:
"How to install the product using the Mounting Bracket" below
l
"How to replace the Mounting Bracket with the DIN Rail Mounting Clip or vice versa" on the next
l
page
"How to install/ remove the product on/ from a DIN Rail" on page 103
l
16.1

How to install the product using the Mounting Bracket

To install the product in place, complete the following steps:
1. See
2. Use the 4 slots available on the Mounting Bracket
3. Add all the necessary mounting hardware to safely fasten the ReliaGATE 10-12 in place according
to your installation requirements (for example use 4x M5 screws, with a minimum length of 15 mm).
Material, type, and length of the screws, and the maximum torque applicable, depend on
your installation requirements.
To simplify the installation, the ReliaGATE 10-12 is already provided with a Mounting Bracket.
The Mounting Bracket is made of 2 mm aluminum alloy 6061 T6.
In case of uncertainties contact the Eurotech Technical Support Team (see
technical assistance" on
"Mechanical specifications" on page 97
page 17).

16 How to install the product

"How to receive
99 / 118