The Software; The Linux Os Distribution; The Bootloader Procedure; How To Create And Use A Bootable Microsd Card For A Linux Release - Eurotech ReliaGATE 10-12-6 Series User Manual

ReliaGATE 10-12 User manual Rev. 2-1
10 T S
HE
10.1

The Linux OS distribution

Eurotech provides a Linux distribution based on a Yocto framework, www.yoctoproject.org, as well as an
SDK for application development.
All the documentation for the developer is available from:www.yoctoproject.org/documentation.
10.2

The bootloader procedure

The ReliaGATE 10-12 boots from eMMC or SD card according to the status of the Boot selection jumper
(JP2) available in the Service Panel:
JP2 status
Inserted
Removed
For advanced boot options see
10.3 How to create and use a bootable MicroSD card for a Linux
release
To create a bootable micro SD card and use it to install the Linux release to the internal eMMC (flash)
device, refer to the README file accompanying the Linux release.
10.4

Ensure power supply during installation and update

If the system only runs Linux: During installation and update, ensure a reliable source of power for the
duration of the install process and for a period of 30 seconds after the first boot.
If the system runs ESF: During installation and update, ensure a reliable source of power for the duration
of the install process and for a period of 3 minutes after the first boot.
NOTICE
If the power supply is interrupted prematurely, this may result in a file corruption.
This failure will not be covered under warranty.
OFTWARE
Boot from
Micro-SD card.
If the Micro-SD card is not found, the ReliaGATE 10-12 boots from eMMC.
eMMC
Figure 10.1 - Boot selection jumper (JP2) layout
"Appendix 1: Advanced boot options" on

10 The Software

Note
This is the default configuration
page 111.
67 / 118