Table of Contents
Advertisement
ReliaGATE 10-12 User manual Rev. 2-1
11
H
OW TO LOGIN THE
This section describes how to login the Administration Console to access the ReliaGATE 10-12 Linux
Operating System.
To login the Administration Console, use one of the following methods:
Direct login via Console Port
l
Remote login via Secure Shell (SSH)
l
11.1
Default credentials
By default the system provides two users:
guest
l
root
l
The guest password is Eurotech and it provides non root privileges.
The root password is set by default to the serial number of the device
11.2
How to login using the Serial Console
To login using the Serial Console, complete the following steps:
1. Setup a Development PC (for example: a laptop) with a free USB port
2. Make sure that both the Development PC and the ReliaGATE 10-12 are turned OFF
3. Connect the TTL-to-USB Cable between the USB port (of the Development PC) and the TTL Serial
Console (of the ReliaGATE 10-12)
4. Turn ON both the Development PC and the ReliaGATE 10-12
5. Use the Development PC to login the Administration Console:
11.3
How to Login Via Secure Shell (SSH)
The default (out-of-the-box) network configuration of the ReliaGATE 10-12 is as follows:
eth0
l
eth1
l
wlan0
l
a. Run a terminal emulator (example: Tera Term on Windows)
b. Configure the serial port connection with these parameters: 115200, 8 bits, 1 stop bit, no
parity, no flow control
c. Enter the default case-sensitive credentials when the prompt appears (see
credentials"
above).
You will obtain a video output like the following:
root
Password:
root@productname...:~#
Status: Enabled for LAN
o
Configure: Manually (Static IP)
o
IP Address: 172.16.0.1
o
Subnet Mask: 255.255.255.0
o
DHCP Server Enabled
o
Status: Enabled for WAN
o
Configure: DHCP (DHCP client)
o
Status: Disabled
o
A
DMINISTRATION
11 How to login the Administration Console
C
ONSOLE
"Default
69 / 118
Advertisement
Table of Contents
