Mixing pump G 4 X FU 230/400V Overview - Operation
Apply mortar
37.2 Interruption of work
1
Fig. 66: Closing the air tap
37.3 In case of longer interruption of work/break
Fig. 67: Closing the air tap
Fig. 68: Switching off
37.4 Switch off air compressor
Fig. 69: Air compressor
42
1. Close the air tap (1) if you interrupt your work for a short while.
2. The machine stops.
3. Once you open the air tap (1), the machine will start-up again.
1
1. Close air tap (1).
2. Switch off the machine at selector switch of the pump motor (2)
(position "0").
2
1. Switch off the air compressor using the green toggle switch (1).
2. Open the air tap at the spraying gun.
1
NOTE!
Always observe the setting time of the material to be
processed:
Clean the system and mortar hoses depending on
the setting time of the material and the length of the
interruption (pay attention to outside temperature).
The guidelines of the material manufacturers have to
be observed regarding breaks.
DANGER!
Risk of injury from discharged mortar!
Discharged mortar may lead to injuries to eyes and
face.
Attention, residual pressure.
2020-01-07