Functional Description G 4 X Fu 230/400V; Fields Of Application; Material; Flowability / Flow Characteristics - PFT G 4 X FU Series Operating Manual

19.2 Functional description G 4 X FU 230/400V

Fig. 29: Functional description

19.3 Fields of application

20 Material:

20.1 Flowability / Flow characteristics

NOTE!
 The pump SD6-3 can be used up to 20 bar operating pressure.
 The possible conveying distance depends mainly on the flowability of the material.
 If 20 bar operating pressure are exceeded the mortar hose length has to be reduced.
 In order to avoid machine faults and increased wear of the pump motor, pump shaft and the
pump itself, only original PFT spare parts such as
 PFT rotors
 PFT stators
 PFT agitators
 PFT mortar hoses must be used.
 These are compatible with each other and form a constructive unit with the machine.
 Non-compliance does not only cause loss of guarantee, but also bad mortar quality is to be
expected.
2020-01-07
Mixing pump G 4 X FU 230/400V Overview - Operation
The new mixing pump G 4 X with 230V AC or 400V three-phase
drive was specially developed for pumping, spraying and applying
of dry mortar, pasty materials for machine use and much more up
to 2 mm grain size.
The pump output can be adjusted by means of a quick pump
change depending on the requirements.
In 230V operation, the litre output can be set in the control cabinet
via the potentiometer.
The machine can be filled with bagged material as well as directly
from a silo/container by means of delivery hood or injection hood
and PFT SILOMAT installation.
For pumpable pre-mixed dry mortar such as:
 gypsum plasters
 lime/gypsum plasters
 cement plasters
 lime plasters
 fango material
 insulation plasters
Material:
 filling plasters
 armour and gluing mortar
 floor screed
 masonry mortar
.... and much more
25