Preparing The Machine; Connecting The Power Supply 400V - PFT G 4 X FU Series Operating Manual

27 Preparing the machine

1
Fig. 35: Grille cover
Fig. 36: Lockable castor

28 Connecting the power supply 400V

1
Fig. 37: Connect power supply 400V
2020-01-07
Mixing pump G 4 X FU 230/400V Overview - Operation
Prior to operating the machine carry out the following steps for
preparing the machine:
DANGER!
Running star wheel!
Risk of injury when reaching into the running star
wheel.
 During machine preparation and operation the
grille cover (1) must not be removed.
 Never reach into the running machine.
1. Lock the lockable castor prior to operating the machine.
2. Put up the machine on a stable, even surface and secure
against unwanted movements:
 Neither tilts nor rolls off the machine.
 Put up the machine in such a way that it cannot be hit by
falling objects.
 The operating elements have to be freely accessible.
 Maintain a clearance of approx. 1.5 metres around the
machine.
1. Connect machine (1) to three-phase network 400V.
NOTE!
The machine can be switched to 230V 1 phase and
operated, although it is connected to a 400V / 3-
phase supply (see page 16, fig.
Advantage: The motor speed can be controlled via
the potentiometer.
Disadvantage: As the machine is controlled via the
frequency converter, the gear motor no longer
reaches its full capacity (maximum 4 kW).
DANGER!
Danger of death from electric current!
The connection line has to be fused properly:
Connect the machine only to a power supply
with permissible RCCB 30 mA RCD (residual
current operated device) type "B" all-current
sensitive
converters.
15:).
for operation of frequency
31