Table of Contents
Advertisement
Pioneer 403MKS
Pioneer Pulse 403MKS
10.3 SYNERGIC MIG/MAG WELDING
Set the welding data (material, wire diameter, gas type), shown on display D4 and just one welding
parameter, chosen among wire feed rate, Amperes, and workpiece Thickness, shown on display D1.
NOTE: The synergic curves were created with reference to a fillet weld in position PB (horizontal-verti-
cal) with 10 mm stick-out (distance from torch to workpiece).
In general, the parameter set is the wire feed rate (associated with the deposition of filler material) and
the synergic welding power source automatically sets the most suitable welding voltage.
Encoder E2 can be adjusted to correct the arc shown on display D3, in order to make minor adjustments
in accordance with requirements.
During a welding operation with an active JOB, it is possible to temporarily change the parameters
shown in the displays D1 and D2 with their encoders to test the temporary changes made to the weld-
ing operation. At the end of the welding operation (and HOLD is quit) the values of the loaded JOB are
reset.
When the welding operation is not being carried out and a JOB is active through encoder E3, the JOBs
belonging to its sequence can be scrolled.
The welding power source also automatically adjusts several secondary parameters that are relevant
for welding quality.
S1
S2
S3
B
S4
SELECTION
WELD THE WORLD
S T O P
L7
L4
E1
D1
S8
D3
S5
C
SETTING
SELECTION
Cod. 006.0001.2230
L8
D2
S10
E3
S6
S7
D
A
A
SELECTION
02/09/2020 V.1.0
ENGLISH
E2
S9
49
Advertisement
Table of Contents
