Synergic Mig/Mag Parameters Setting (1St Level): Synergic Curve Setting; Manual Mig/Mag Parameters Setting (2Nd Level) - Weco Pioneer 403MKS Instruction Manual

Cod. 006.0001.2230
02/09/2020 V.1.0
ENGLISH
S6
This button serves to select the following welding mode:
MODE MODE
SYNERGIC MIG/MAG
S7
Use this button to select one of the following torch trigger procedures:
2 STROKE
2 STROKE SPOT: The procedure is active when the "SPOT TIME" parameter is set to a value other
than "OFF".
A 4 STROKE
4 STROKE B-LEVEL: The procedure is active when the "B-LEVEL" parameter is set to a value other
than "OFF"
3 LEVEL 2 STROKE
3 LEVEL 2 STROKE SPOT: The procedure is active when the "SPOT TIME" parameter is set to a value
other than "OFF". If the "SPOT TIME" parameter is active in the 3 LEVELS procedure, its value denotes
the time for which the main welding current is supplied.
3 LEVEL 4 STROKE
3 LEVEL 4 STROKE B-LEVEL: The procedure is active when the "B-LEVEL" parameter is set to a value
other than "OFF"
Tab. 7 - Main settings and displays in SYNERGIC MIG/MAG mode
Data setting
Welding
HOLD function
(At welding end)

10.3.1 Synergic MIG/MAG parameters setting (1st level): synergic curve setting

B
○ Scroll down the list of parameters to be edited by pressing buttons S3
○ Using the encoder E3
C
The value is saved automatically.

10.3.2 Manual MIG/MAG parameters setting (2nd level)

D
○ Press the button S5
B
○ Scroll down the list of parameters to be edited by pressing buttons S3
○ Using the encoder E3
C
The value is saved automatically.
50
WELD THE WORLD
DISPLAY D1
Shows the main synergy parameter
(wire feed rate, Amperes, recommend-
ed thickness), which can be adjusted
with the following encoder: (E1).
Shows the average current measured
during welding.
Shows the average current measured
during the last welding procedure
performed.
, edit the value of the selected parameter
to enter the 2nd level menu.
, edit the value of the selected parameter
Pioneer 403MKS
Pioneer Pulse 403MKS
DISPLAY D2
Shows the set welding voltage, which
can be adjusted with the following
encoder: (E2).
Shows the arc correction executed by
the operator with encoder (E2).
Shows the arc correction executed by
the operator with encoder (E2).
Shows the average voltage measured
during welding.
Shows the average voltage measured
during the last welding procedure
performed.
and S4
and S4