Preparing For Mma Welding - Weco Cruiser Power Pulse Instruction Manual

Cod. 006.0001.1680
09/06/2020 V.2.10
ENGLISH
• Number and cross section of wires: 4 x 6 mm
• Power plug type: not supplied
○ Socket for connecting the power cable between the power source and the remote control device
[Item 9].
○ (Only Power Pulse 322/402/502T) Connector for connection to the programmer [Item 10]. Pro-
gramming connector for the "pulsed" circuit board. You can update the software of the equipment
using the programming kit.

2.4 PREPARING FOR MMA WELDING

1. Set the welding power source ON/OFF switch to "O" (unit switched off).
2. Plug the power cable plug into a mains socket outlet.
3. Choose the electrode based on the type of material and thickness of the workpiece to be welded.
4. Insert the electrode in the electrode holder.
5. Connect the electrode holder cable to the welding socket based on the polarity requested by the
type of electrode used.
6. Connect the plug of the ground clamp to the welding socket on the basis of the polarity required.
7. Connect the earth clamp to the workpiece being processed.
Read the warnings highlighted by the following symbols in the "General prescriptions for use".
8. Set the welding power source ON/OFF switch to "I" (unit powered).
9. Select the following welding mode on the user interface: MMA
10. Set the required welding parameter values on the user interface.
When the remote controller [RC] is connected and the relative locking screw is tightened, welding
current can be adjusted using the remote controller.
The system is ready to start welding.
REAR VIEW
8
WELD TH E W O R L D
(4 mm
2 2
DANGER!
Electric shock hazard!
(polarity to basic electrode)
RC
Cruiser 322/402/502T
Power Pulse 322/402/502T
on 322T)
FRONT VIEW