Table of Contents
Advertisement
Pioneer 403MKS
Pioneer Pulse 403MKS
10.5 DOUBLE PULSED SYNERGIC MIG/MAG WELDING
(available in PIONEER PULSE MKS line power sources)
Set the welding data (material, wire diameter, gas type), shown on display D4 and just one welding
parameter, chosen among wire feed rate, Amperes, and workpiece Thickness, shown on display D1.
NOTE: The synergic curves were created with reference to a fillet weld in position PB (horizontal-verti-
cal) with 10 mm stick-out (distance from torch to workpiece).
In general, the parameter set is the wire feed rate (associated with the deposition of filler material) and
the synergic welding power source automatically sets the most suitable welding voltage. Encoder E2
can be adjusted to correct the arc shown on display D3, in order to make minor adjustments in accord-
ance with requirements. During a welding operation with an active JOB, it is possible to temporarily
change the parameters shown in the displays D1 and D2 with their encoders to test the temporary
changes made to the welding operation. At the end of the welding operation (and HOLD is quit) the
values of the loaded JOB are reset.
When the welding operation is not being carried out and a JOB is active through encoder E3, the JOBs
belonging to its sequence can be scrolled. The welding power source also automatically adjusts several
secondary parameters that are relevant for welding quality. This mode involves a variable frequency
pulse between two parameters of the Pulsed Synergic curve.
S1
S2
S3
B
S4
SELECTION
WELD THE WORLD
S T O P
L7
L4
E1
D1
S8
D3
S5
C
SETTING
SELECTION
Cod. 006.0001.2230
L8
D2
E2
S10
E3
S6
S7
A
D
A
SELECTION
02/09/2020 V.1.0
ENGLISH
S9
57
Advertisement
Table of Contents
