Table of Contents
Advertisement
Pioneer 403MKS
Pioneer Pulse 403MKS
3
USER INTERFACE
S1
S2
S3
S4
CODE
SYMBOL
L1
L2
L3
L4
L5
L6
L7
WELD THE WORLD
L7
E1
D1
D3
DESCRIPTION
illumination shows that the following parameter can be set: WIRE FEED RATE
The value appears on the following display: D1
Short-Spray, pulsed and synergic MIG/MAG welding:
illumination shows that the following parameter can be set: WELDING CURRENT
HOLD function (at welding end):
Illuminates to show a value in the following unit of measurement: AMPERES
The value appears on the following display: D1
illumination shows that the following parameter can be set: WELDING THICKNESS
(Reference is made to "T" fillet welds on identical thicknesses. The relative value is purely
guideline).
The value appears on the following display: D1
Illuminates to show the last voltage and current values measured during welding.
The LED switches off when a new welding procedure is started, or when any of the welding
settings is modified.
The value appears on the display : D1-D2
Illuminates to show a value in the following unit of measurement: MILLIMETRES
Illuminates together with the following LED:
The value appears on the following display: D1
Illuminates to show a value in the following unit of measurement: METRES PER MINUTE
Illuminates together with the following LED:
The value appears on the following display: D1
This LED illuminates to show an anomaly in the operating conditions.
An alarm message appears on the following display: D3
§ "7 ALARM MANAGEMENT"
S T O P
L4
L8
S8
E3
S5
S6
Cod. 006.0001.2230
02/09/2020 V.1.0
ENGLISH
D2
E2
S10
S9
S7
17
Advertisement
Table of Contents
