Table of Contents
Advertisement
Pioneer 403MKS
Pioneer Pulse 403MKS
10.2 MANUAL MIG/MAG WELDING
Welding is of the Short/Spray type.
Adjustment of the main welding parameters, wire feed rate and voltage is entirely at the discretion of the
operator. The optimal work point must be identified for the required welding type.
During a welding operation with an active JOB, it is possible to temporarily change the parameters
shown in the displays D1 and D2 with their encoders to test the temporary changes made to the weld-
ing operation. At the end of the welding operation (and HOLD is quit) the values of the loaded JOB are
reset.
When the welding operation is not being carried out and a JOB is active through encoder E3, the JOBs
belonging to its sequence can be scrolled.
S1
S2
S3
D
S4
SELECTION
S6
This button serves to select the following welding mode:
MODE
MODE
MANUAL MIG/MAG
S7
Use this button to select one of the following torch trigger procedures:
A
2 STROKE
2 STROKE SPOT: The procedure is active when the "SPOT TIME" parameter is set to a value other
than "OFF".
4 STROKE
WELD THE WORLD
S T O P
L7
L4
E1
D1
S8
D3
S5
B
SETTING
SELECTION
Cod. 006.0001.2230
02/09/2020 V.1.0
L8
D2
E2
S10
S9
E3
S6
S7
C
A
A
SELECTION
ENGLISH
47
Advertisement
Table of Contents
