Unit Power-Up; Reset (Load Factory Settings) - Weco Pioneer 403MKS Instruction Manual

Cod. 006.0001.2230
02/09/2020 V.1.0
ENGLISH
4

UNIT POWER-UP

Set the welding power source ON/OFF switch to "I" to switch on the unit.
First power-up or power-ups following a RESET procedure
The welding power source sets up for welding with the factory preset values..
Subsequent power-ups
The welding power source sets up for welding in the latest stable welding configuration that was
active at the time of power-off.
During power-up all functions are inhibited and the following displays remain blank: D1, D2
D3: The following messages will appear in sequence on this display:
Tab. 1 - Messages at power-up
MOTOR BOARD
FW: XX.XX.XXX
PROGRAM UPDATE
PIONEER ZZZ
FW: YY.YY.YYY
WELDING MACHINE OK
5

RESET (LOAD FACTORY SETTINGS)

To perform a reset the power source must be managed via the remote control.
The reset procedure involves complete restoration of the default values, parameters and memory set-
tings set in the factory.
The reset procedure is useful in the following cases:
- Too many changes made to the welding parameters so user finds it difficult to restore defaults.
- Unidentified software problems that prevent the welding power source from functioning correctly.
20
WELD THE WORLD
XX.XX.XXX= wire feeder software version.
The welding power source is synchronising the wire feeder and
power source software.
ZZZ= Ampere value of the power source.
YY.YY.YYY= power source software version.
Pioneer 403MKS
Pioneer Pulse 403MKS