Table of Contents
Advertisement
Cod. 006.0001.2230
02/09/2020 V.1.0
ENGLISH
Tab. 5 - Main settings and displays in MANUAL MIG/MAG mode
Data setting
Welding
HOLD function
(At welding end)
10.2.1 Manual MIG/MAG parameters setting (1st level): inductance setting.
○ Using the encoder E3
B
The value is saved automatically.
IND: This parameter allows electronic adjust-
ment of the welding inductance from the main
menu.
10.2.2 MANUAL MIG/MAG PARAMETERS SETTING (2ND LEVEL)
C
○ Press the button S5
D
○ Scroll down the list of parameters to be edited by pressing buttons S3
○ Using the encoder E3
B
The value is saved automatically.
Tab. 6 - 2nd level menu parameters in MANUAL MIG/MAG mode
PROCEDURE
INDUCTANCE
PRE GAS
SOFT START
BURN BACK
2 STROKE
2 STROKE SPOT
POST GAS
SPOT TIME
INDUCTANCE
PRE GAS
SOFT START
4 STROKE
BURN BACK
POST GAS
48
WELD THE WORLD
DISPLAY D1
Shows the wire feed rate setting in m/
min, which can be altered by means of
the following encoder: (E1).
Shows the average current measured
during welding.
Shows the average current measured
during the last welding procedure
performed.
, edit the value of the selected parameter
to enter the 2nd level menu.
, edit the value of the selected parameter
PARAMETER
MIN
(row 1/6)
-100
(row 2/6)
0.0 s
(row 3/6)
1 %
(row 4/6)
1 %
(row 5/6)
0.0 s
(row 6/6)
0.1 s
(row 1/5)
-100
(row 2/5)
0.0 s
(row 3/5)
1 %
(row 4/5)
1 %
(row 5/5)
0.0 s
Shows the set welding voltage, which
can be adjusted with the following
Shows the average voltage measured
Shows the average voltage measured
during the last welding procedure
SHORT/SPRAY
IND
100
DEFAULT
MAX
0
100
0.0 s
10.0 s
35 %
100 %
25 %
200 %
1.0 s
10.0 s
The parameter value is saved for each
OFF
25.0 s
0
100
0.0 s
10.0 s
35 %
100 %
25 %
200 %
1.0 s
10.0 s
Pioneer 403MKS
Pioneer Pulse 403MKS
DISPLAY D2
encoder: (E2).
during welding.
performed.
MAN
and S4
NOTES
welding mode.
Advertisement
Table of Contents
