Mitsubishi MOTORS Colt 2007 Owner's Manual page 92

Seat and seat belts
5. After confirming that the belt is locked, grab the shoulder
part of the belt near the buckle and pull up to remove any
slack from the lap part of the belt. Remember, if the lap
part of the belt is not tight, the child restraint will not be
secure. It may help to put weight on the child restraint, or
push on the seatback while pulling up on the belt.
2
6. Before putting the child in the restraint, push and pull the
restraint in all directions to be sure it is secure. Do this
before each use.
NOTE
● If the seat belt does not lock, rewind it fully then perform
step 2 to 6 again.
2-44
WARNING
!
● Before putting the child in the restraint, be abso-
lutely sure to make the conversion of the retractor
from the ELR mode to the ALR mode. By doing so,
the child restraint system is always tightly secured to
the seat by the automatic lock. If the conversion to
ALR is not made, the child restraint system could
move forward in the event of sudden braking or an
accident, seriously injuring the child or other occu-
pants.
To remove
1. Remove the plate from the buckle, then remove the seat
belt from the child restraint system.
2. Fully rewind the seat belt to deactivate the ALR mode.