To install
1. Place the child restraint system in the rear seating position
as shown in the illustration.
2. Route the belt through the child restraint according to the
child restraint system manufacturer's instructions, then
insert the latch plate into the buckle.
3. To activate the ALR mode, slowly pull the shoulder part
of the belt all the way out until it stops, then let the belt
feed back into the retractor.
4. After the belt has retracted, tug on it. If the belt is locked,
you will not be able to pull it out. If you can pull the belt
out, it is not locked and you will need to repeat these
steps.
Seat and seat belts
2
2-43