Mitsubishi MOTORS Colt 2007 Owner's Manual page 309

16. When you have inflated the tyre to the specified pressure,
stow the compressor and bottle in the vehicle and
promptly start driving the vehicle so that the tire sealant
can spread evenly in the tyre. Drive with great care. Do
not exceed a speed of 80 km/h (50 mph). Observe local
speed limits.
Remove the "max. 80 km/h (50 mph)" or "max. 50 mph"
label from the bottle, that must be displayed on the instru-
ment panel within the driver's field of view.
CAUTION
!
● If you sense any abnormality while driving, stop the
vehicle and contact a MITSUBISHI MOTORS
Authorized Service Point or another specialist. Oth-
erwise the tyre pressure may drop before the emer-
gency repair procedure is completed, rendering the
vehicle unsafe.
NOTE
● Driving faster than 80 km/h (50 mph) can make the vehi-
cle vibrate.
17. After driving for 10 minutes, check the tyre pressure using
the air pressure gauge on the compressor.
If the tyre pressure is not sufficient, inflate the tyre to the
specified pressure again and drive the vehicle carefully
without exceeding a speed of 80 km/h (50 mph).
CAUTION
!
● If the tyre pressure is lower than the minimum per-
mitted pressure (1.3 bar {130 kPa}), the tyre cannot
successfully be repaired with the tyre sealant. Do not
drive the vehicle
MITSUBISHI MOTORS Authorized Service Point
or another specialist.
For emergencies
any further. Contact
6-19
a
6