Mitsubishi MOTORS Colt 2007 Owner's Manual page 210

Starting and driving
Traction control system (TCL)/Active stability
control system (ASC) indicator lamp
The traction control system (TCL) and active stability control
system (ASC) share the same indicator lamp.
The indicator lamp should illuminate when the ignition switch
is turned to the "ON" position, and should go off after a few
seconds. Always make sure that the lamp goes off before
begining to drive.
If the indicator lamp stays on or does not illuminate when the
ignition switch is turned to the "ON" position, we recommend
that you consult a MITSUBISHI MOTORS Authorized Serv-
ice Point.
indicator lamp blinks when the traction control system
(TCL) or active stability control system (ASC) is operating.
4
4-44
CAUTION
!
● When
the indicator lamp blinks, the traction con-
E00612100092
trol system (TCL) or active stability control system
(ASC) is operating, which means that the road is
slippery or that your vehicle's wheels are slipping
excessively. If this happens, drive more slowly with
less accelerator input.
● If a malfunction occurs in the device, the
tor lamp will illuminate continuously. Park your
vehicle in a safe place and stop the engine. Then
start the engine again and check whether the
indicator lamp goes out.
If the indicator lamp remains on even after your
vehicle is driven a short distance after starting the
engine, we recommend that you consult a
MITSUBISHI MOTORS Authorized Service Point.
indica-