Table of Contents
Advertisement
Figure 2-6. LED and Push Button Locations
Power LED (LED10)
When
is lit (green), it indicates that power is being properly sup-
LED10
plied to the board.
USB Monitor LED (LED13)
The USB monitor LED (
been initialized successfully and you may connect to the processor using a
VisualDSP++ EZ-KIT Lite session. Once the USB cable is plugged into
the board, it takes approximately 15 seconds for the USM monitor LED
ADSP-21364 EZ-KIT Lite Evaluation System Manual
EZ-KIT Lite Hardware Reference
) indicates that USB communication has
LED13
2-13
Advertisement
Table of Contents
